Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Aldine, TX
Gate access control in Aldine usually starts with a flooded operator or a keypad that stopped reading codes after the last storm. The work here leans toward electrical diagnosis, board replacement, and rewiring underground conduit that Harris County’s clay soil has pulled apart over time. We serve Aldine with written pricing before any work starts, and a live person answers at (936) 297-5126 at any hour.
Why Aldine Homes Are Different
Aldine sits in the Greens Bayou floodplain in unincorporated Harris County. That single fact changes gate work more than anything else. Operators get submerged during heavy rain events, and when the water recedes, circuit boards are dead and posts have tilted in saturated clay. Because Harris County has no city-level building department, many gates in Aldine were installed without inspection. We regularly open control boxes and find DIY wiring, missing grounds, and operators wired with wire nuts that were never rated for burial.
The housing stock is mostly 1970s through 1990s single-family homes and mobile home parks, many enclosed with ornamental iron or chain-link sliding gates. Along the Hardy Toll Road and I-69/US-59 corridors, heavy commercial sliding gate work is common. The clay soil heaves seasonally, so a gate that closed perfectly in March can bind by August. Humidity and Gulf air accelerate rust on bare steel and wrought iron, which means hinge and post repairs show up early in Aldine compared to drier markets.
Our Main Aldine Services
Most Aldine homeowners call about one of three things: a gate that stopped moving, a gate that needs to be installed or replaced, or a motor that died. Each service page covers pricing, signs, and what the job involves here.
Gate Repair in Aldine
Repair work in Aldine usually means finding what water, clay movement, or rust has already damaged. We check the operator, the limit switches, the photo-eyes, and the physical gate hardware, then hand you a written price before any work begins. If a post has heaved out of plumb, that gets addressed before the gate is rehung so the repair does not fail in six months. Gate Repair in Aldine covers the full scope.
Gate Installation in Aldine
Installations in Aldine need to account for expansive clay and flood elevation. We set posts deeper than the minimum and use concrete that can handle wet-dry cycles. Since there is no local inspection requirement, we verify our own work with a photo record at every stage and leave you the documentation. Gate Installation in Aldine walks through design, materials, and written pricing.
Gate Motor & Opener in Aldine
Flood-killed operators are the most common motor call in Aldine. The question is whether the board, the motor, or both are gone. We service nine automation brands and will tell you plainly if the unit can be saved or if replacement is the better use of your money. Gate Motor & Opener in Aldine has the detail.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Aldine
Gate access control in Aldine is a different animal than the rest of the gate trade. Homes here sit in a floodplain, so keypads, card readers, and phone-entry boards are regularly killed by moisture and power surges. Industrial facilities along the Hardy Toll Road need heavier-duty access systems, and we work on those too, from Viking and DoorKing telephone entry to Ghost Controls residential keypads. Under the Haven Standard, every access control job gets a written price before work and a documented photo record after. Learn more on our Gate Access Control page.
Keypad Entry
Signs you need it
The keypad lights up but does not send a signal, or the buttons work intermittently after rain.
What it costs in Aldine
Keypad replacement in Aldine typically runs $150 to $400, and that includes wiring verification.
How we do it
We open the housing, check for corrosion and failed seals, then replace the keypad and apply fresh dielectric grease before closing it up.
Phone Entry
Signs you need it
The system does not dial the programmed number, or callers get dropped as soon as the gate relay closes.
What it costs in Aldine
Phone entry repairs in Aldine run $200 to $600 depending on whether the board or the relay is at fault.
How we do it
We test the relay, check the telephone line voltage, and document the board settings before replacing or reprogramming the unit.
Card Reader
Signs you need it
Cards read intermittently, or the reader beeps but never triggers the gate operator.
What it costs in Aldine
Card reader replacement in Aldine typically runs $250 to $550 supplied and installed.
How we do it
We test the reader’s output, verify the wiring back to the controller, and install a replacement if the reader has failed.
What Access Control Costs in Aldine
| Item | Typical range in Aldine |
|---|---|
| Keypad replacement | $150 to $400 |
| Phone entry repair | $200 to $600 |
| Card reader replacement | $250 to $550 |
Can you fix a flooded keypad the same day?
Yes. If the keypad took on water, we can usually replace it same-day and re-seal the housing. Call (936) 297-5126 for the next available window.
Do you work on commercial access systems in Aldine?
We do. DoorKing and Viking phone entry along the Hardy Toll Road corridor are common jobs. Estimates are free and written before work starts.
Gate Parts & Welding in Aldine
Gate parts and welding in Aldine is where the clay soil and the Gulf humidity show up hardest. Hinges rust through, posts heave out of plumb, and sliding gate rails take hits from yard traffic. We keep common parts on the truck and weld on site, documenting each repair with photos before we leave. Our Gate Parts & Welding page covers the full range.
Hinge Replacement
Signs you need it
The gate sags on one corner or scrapes the ground when opening and closing.
What it costs in Aldine
Hinge replacement in Aldine runs $120 to $400 per hinge depending on gate weight and access.
How we do it
We support the gate with a jack, cut or unbolt the old hinge, and weld or bolt in a replacement matched to the gate’s material and weight.
Post Replacement
Signs you need it
The post leans visibly, the gate no longer latches, or a gap opens between gate leaf and post after a dry spell.
What it costs in Aldine
Post replacement in Aldine typically runs $350 to $900 depending on depth, concrete, and whether we remove the old post or dig alongside it.
How we do it
We dig out the old post, set a new one deeper in fresh concrete, and use a level to confirm plumb before the concrete cures.
Rail Repair
Signs you need it
The sliding gate jerks, binds, or makes a grinding sound where the wheels ride the rail.
What it costs in Aldine
Rail repair in Aldine runs $200 to $600 depending on whether we can true the existing rail or need to splice in a new section.
How we do it
We check the rail for bends and rust-through, straighten or cut out the damaged section, and weld in replacement stock.
What Gate Parts & Welding Costs in Aldine
| Item | Typical range in Aldine |
|---|---|
| Hinge replacement | $120 to $400 per hinge |
| Post replacement | $350 to $900 |
| Rail repair | $200 to $600 |
Can you weld a broken ornamental iron gate in Aldine?
Yes. We weld on site and match the repair to the existing material. Call (936) 297-5126 and we’ll bring the right rod and a written price.
Does post replacement fix a gate that won’t close after rain?
Almost always, yes. Aldine’s clay soil moves posts more than any other single factor. We re-set and re-level, then verify the gate’s swing path.
Brands We Service in Aldine
We carry parts for Ghost Controls, DoorKing, Viking, and Elite operators, among others. Turnaround on common boards and remotes is typically same-visit or next-day. See our brands for the full list.
Pricing for Gate Repair in Aldine, TX
| Service | Typical range in Aldine |
|---|---|
| Keypad entry replacement | $150 to $400 |
| Phone entry repair | $200 to $600 |
| Card reader replacement | $250 to $550 |
| Hinge replacement | $120 to $400 per hinge |
| Post replacement | $350 to $900 |
| Rail repair | $200 to $600 |
| Gate operator motor replacement | $450 to $1,100 |
| Control board replacement | $250 to $600 |
| Photo-eye replacement | $120 to $300 |
| Limit switch adjustment | $100 to $250 |
| Solar panel installation | $350 to $800 |
| Chain or belt drive replacement | $250 to $550 |
Flood damage, badly heaved posts, and rusted hardware push prices toward the higher end in Aldine. The written price we hand you before work starts is the price you pay, no surprise add-ons later.
Neighborhoods We Serve in Aldine
We work all over Aldine, from the residential streets near Aldine High School to the industrial corridors along the Hardy Toll Road. Typical response time is same-day for emergency calls and within one business day for scheduled work.
- Greens Bayou area
- North Side
- East Aldine
- Westfield
- Hardy Toll Road corridor
Service Area - Cities Near Aldine
From Aldine we also serve homeowners and businesses in Conroe, TX, Willis, TX, The Woodlands, TX, and Pinehurst, TX. Dispatch is coordinated from our Houston office, with crews serving Aldine locally.
Serving Aldine, TX - Our Local Coverage Area
We’re based in the Aldine area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Aldine
Same-day for emergencies, typically within one business day for scheduled work. A live person answers the phone 24/7 at (936) 297-5126, no voicemail loop.
Because Aldine is unincorporated Harris County, there is no city-level permit process for gate repair. We still document every job with photos and a written record so you have the evidence in hand.
Yes. Post movement from clay heave throws gate travel off, which makes the operator work harder and shortens its lifespan. We address the post first, then the electronics.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Aldine Customers Say
"The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Honest about what did not need doing. Told me the operator had years left and only the control board needed replacing."
- Douglas N."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B.